MINIBIKE
HOW TO SECTION - CLUTCH
For sales and technical
support
909-554-0054
We have receive many E-mails with questions on how to install some of the components used on
Minibikes so we decided to insert a HOW TO SECTION to help the home builder with there projects.
we'll be starting this information service with just a few basic page's but as more questions are asked
more pages will be added book mark us and check back often THANK YOU
If you have a question about your project please contact us.

CONTACT US
This is the most common installation used on minibikes
Clutches are non-directional and can be mounted with
the sprocket facing out board or in board facing the
engine
Clutch maintenance is important and is the most
over looked procedure on the vehicle. If your
minibike wants to move at low RPM idle or will not
coast after throttling down  you may need to oil the
clutch bushing
Look close and you can see a brass
bushing between the snap ring eyes,
THIS IS WHERE YOU NEED TO OIL
Use a 3 n1 type oil or light motor oil only
CAUTION DO NOT USE
WD-40
ONLY PUT 2 OR 3 DROPS OF OIL WHERE YOU
SEE THE BRASS BUSHING DO NOT OVER OIL
_________________________