MINIBIKE
HOW TO SECTION -TRI STAR WHEEL
USE BACK ARROW TO
RETURN TO ASSEMBLY
INSTRUCTIONS
1:  BEFORE YOU ASSEMBLE THE WHEELS READ THE INSTRUCTION BOOKLET THAT'S PROVIDED

2:   Before you try to mount the tire onto the wheel check the wheel bearings to make sure the bearing is totally pressed in to wheel
socket

TIP  use a block of wood and a small hammer to gently tap on edge of the bearing making sure bearing is level in wheel socket

3:    Pre-assemble the wheels with out the tires be sure to insert the axle into the bearing of the 2 wheel halves, that will align the wheel
halves,now bolt the 2 wheel halves together using the bolts that are provided, now set one side of the axle on edge of a table, now
holding the other side of the axle in your hand spin the wheel to see if wheel runs true if it does not loosen the 3 bolts slightly tap on outer
edge of the rim with a
soft hammer being careful not to break the wheel edge. Now re-tighten the bolts check again. Do this until wheel is
true. Do the same with the rear wheel with sprocket hub installed

TIP  If you can easily remove the axle from the wheel your wheel should be true spinning

TIP  The wheels are cast aluminum wheels so there may be some flashing around the top edge THIS MUST BE REMOVED or wheel will
never align

TIP  Tire tube holes must together as in above graphic

Take your time, Do the front wheel first for practice  if you still need help Call us at 909-554-0054
Hours of Operation
Monday - Friday
9:00 am to 3:00 pm PDST
909-554-0054