(909) 554-0054
BACK TO HOW TO PAGE
CLICK HERE
HOW TO CLUTCH
Clutch maintenance is important and is the most
over looked procedure on the vehicle. If your
racer or kart wants to move at low RPM idle or will
not coast after throttling down  you may need to oil
the clutch bushing
_________________________
Look close and you can see a brass
bushing between the snap ring eyes,
THIS IS WHERE YOU NEED TO OIL
Use a 3 n1 type oil or light motor oil only
ONLY PUT 2 OR 3 DROPS OF OIL WHERE YOU
SEE THE BRASS BUSHING DO NOT OVER OIL
CAUTION DO NOT USE
WD-40
Clutches are non-directional and can be mounted with
the sprocket facing out board or in board facing the
engine
Typical in board installation, note
bolt and washer to secure clutch on
to the shaft
Typical out board installation, note
bolt and washer to secure clutch on
to the shaft
This is the most common installation
used on minibikes and barstool racers
Please  Note  The assembly instructions are for general installation and may
very from racer to racer . Parts shown may differ as illustrated