HOW TO BC-1 CALIPER
| BACK TO HOW TO PAGE CLICK HERE |
Please note when you weld on the frame bracket
it must be positioned for the size of rotor used
it must be positioned for the size of rotor used
Typical installation of Billet Caliper
Parts needed for this install
1 weld on frame bracket
1 BC-1 caliper
1 1 rotor
1 3" return spring
2 Swivel pins with holes
1 cable stop
1 brake cable
All parts shown are available in our brake page
Parts needed for this install
1 weld on frame bracket
1 BC-1 caliper
1 1 rotor
1 3" return spring
2 Swivel pins with holes
1 cable stop
1 brake cable
All parts shown are available in our brake page
(909) 554-0054
| When installing the new billet caliper you will notice it is self centering when used in conjunction with our new brake bracket Cable can be installed on left or right side as needed for your application. |
| This is the new caliper bracket use with the MB1 caliper or with our new Billet caliper. This bracket allows the caliper to float so the old C bracket is not needed. This bracket is installed on all of our barstool frames |
| This is the old caliper bracket use with the MB1 caliper, with this bracket you must use a C bracket to make caliper float |
Please Note The assembly instructions are for general installation and may
very from racer to racer . Parts shown may differ as illustrated
very from racer to racer . Parts shown may differ as illustrated